• This topic has 2 replies, 3 voices, and was last updated January 18, 2021 by Chris R.

change VRA network switch

  • Mario R
    November 16, 2020 09:34:42 AM

    Dear support,

    is it possible to change the virtual switch for a VRA? In vCenter, you should not change VRAs, but over Zerto management console it´s only possible to set the virtual switch which should be uses for VRA during installation of the VRA. Once the VRA is setup and you want to edit it, you can only change IP but not the vswitch.

    Thanks,

    Mario

    George L
    January 15, 2021 08:21:45 PM

    Hi Mario.  I have the same question and will likely need to reach out to support to determine how to rehome the VRA to a different vSphere port group.  I will update thread once I get this figured out.

    Chris R
    January 18, 2021 08:59:00 AM

    Hi All,

    My initial thoughts would be to :

    1. remove all outbound replication traffic from VRA ( Source VRA)
    2. remove all inbound replication traffic (Recovery VRA)
    3. remove VRA from Zerto UI
    4. RE-deploy Zerto VRA from Zerto UI onto new port group

    Kind Regards

    Chris Rogers

The forum ‘VMware’ is closed to new topics and replies.