Ryan's Profile

Hi, Thank you for your answers Chris and Kalsang. So just to be sure I get this right, if I update to Zerto 8.5U2 which supports all there is to support including VM hardware version from 7 to 18, I can have my VMs on vm hw v18 on ESXi 7.0 hosts and replicate them […]

Hi, I know I am a little late for the party but I just wanted to add to this question: would it be possible to replicate from higher to lower version of ESXi, ie. 7.0 to 6.5? are there any limitations in doing that? Let’s say to keep VM hardware version 13 (as supported by […]

Hi, According to ReleaseNotesforZerto8.0U2-Rev07 http://s3.amazonaws.com/zertodownload_docs/Latest/Zerto%20Virtual%20Replication%20Release%20Notes.pdf?cb=1584625030 on page 17 SCVMM 2019 and Hyper-V 2019 are now supported   Cheers

I had the same issue after upgrading Zerto in 1 site (other was fine after upgrade). In my case the solution was to run Zerto Diagnostics -> Reconfigure Zerto Virtual Manager which basically was next,next,next. After installer has finished, my service was up and running and I could finally log in. Hope this helps. Regards